Table of Contents
Advertisement
SYMPTOM: The incline trainer will not connect to
the wireless network
a. Make sure that the wireless settings on the console
are correct (see page 22).
b. Make sure that the settings for your wireless net-
work are correct.
c. If you still have questions, go to my.iFIT.com.
SYMPTOM: The console does not stay in place
a. If the console will not stay in the desired position
because it is too loose, turn a hex key in quarter
turn increments in the two indicated locations (E)
until the console is tightened.
a
E
SYMPTOM: The walking belt slows when walked on
a. If an extension cord is needed, use only a 3-conduc-
b. If the walking belt is overtightened, incline trainer
E
c. The incline trainer features a walking belt coated
d. If the walking belt still slows when walked on,
27
tor, 14-gauge (2 mm
) cord that is no longer than
2
5 ft. (1.5 m).
performance may decrease and the walking belt
may become damaged. First, remove the key and
UNPLUG THE POWER CORD. Using the hex key,
turn both idler roller screws (F) counterclockwise,
1/4 of a turn. When the walking belt is properly
tightened, you should be able to lift each edge of
the walking belt 3 to 4 in. (8 to 10 cm) off the
walking platform. Be careful to keep the walking
belt centered. Then, plug in the power cord, insert
the key, and walk on the incline trainer for a few
minutes. Repeat until the walking belt is properly
tightened.
b
F
with high-performance lubricant. IMPORTANT:
Never apply silicone spray or other substances
to the walking belt or the walking platform
unless instructed to do so by an authorized
service representative. Such substances may
deteriorate the walking belt and cause exces-
sive wear. If you suspect that the walking belt
needs more lubricant, see the front cover of this
manual.
please see the front cover of this manual.
8–10 cm
Advertisement
Table of Contents
