NordicTrack NTL39221-INT.1 User Manual page 26

SYMPTOM: The displays of the console do not
function properly
a. If the console does not display speed or distance
properly, remove the key from the console and
UNPLUG THE POWER CORD. Next, remove the
indicated #8 x 3/4" Self-tapping Screw (5), and lift
off the Left Foot Rail Cover (44).
a
Next, locate the Reed Switch (121) and the
Magnet (120) on the left side of the Pulley (42).
Turn the Pulley until the Magnet is aligned with the
Reed Switch. The gap between the Magnet and
the Reed Switch must be about 1/8 in. (3 mm). If
necessary, loosen the #8 x 3/4" Clip Screw (119),
move the Reed Switch slightly, and then retighten
the Clip Screw. Then, reattach the Left Foot Rail
Cover (see the drawing above), and run the incline
trainer for a few minutes to check for a correct
speed reading.
Top View
119
121
3 mm
44
5
120
42
b. If the console does not boot up properly, or if the
console freezes and does not respond, reset the
console to the factory default settings.
IMPORTANT: Doing this will erase all of the
custom settings that you have made to the
console. Resetting the console requires two
people. First, press the power switch into the off
position. Next, locate the indicated small opening
(D) on the top of the console. Using a bent paper
clip (E), press and hold the small button inside of
the opening and have a second person press the
power switch into the on/reset position. Continue to
hold the button inside of the opening until the
console turns on. When the reset operation is
complete, the console will turn off and then turn
back on. If it does not, use the power switch to turn
the treadmill off and then on again. Once the
console turns on, check for firmware updates (see
step 5 on page 21). Note: It may take up to a few
minutes for the console to be ready for use.
b
26
C
D