Table of Contents
Advertisement
P A G E 8
I N S TA L L AT I O N
Hook-up (Continued)
Step 4: Connect VCP to the TV
Refer to the following illustration to properly connect the VCP to your TV.
1. Connect one end of the round coaxial cable
supplied with your VCP to the RF OUT
terminal of the VCP.
(Back of TV)
VIDEO
IN
AUDIO
VHF/UHF/CATV
IN
Note: An alterative to using the RF cable is to
connect the Audio/Video Out jacks on the VCP
to the corresponding jacks on your TV (if
present). However, these cables are optional
accessories that are not supplied with the VCP
but should be available from your Zenith video
product retailer.
Step 5: Supply Power to the VCP
1. Plug the AC adapter power cord into an
operating 120V AC outlet and the other end
into the DC input on the back of the VCP, or
2. Using the adapter cord, plug one end of the
cord into a 12 volt negative ground DC
source (such as the cigarette lighter socket
of a car) and the other end into the DC
input on the back of the VCP.
Figure 3: Connecting the VCP to Your TV
2. Connect the other end of the cable to the
RF IN (or ANT IN)terminal on your TV.
CHANNEL
VIDEO
OUT
DC IN 12V
AUDIO
OUT
ANT.IN
3
4
RF.OUT
Advertisement
Table of Contents
