Table of Contents
Advertisement
Hook-up (Continued)
Step 3: Connect VCP to Antenna or Cable-TV Line
Your antenna/cable-TV connection will be similar to one of the illustrations below.
Match yours to the one like it and make the connections shown.
1.
Disconnect the antenna or cable-TV line
from the TV.
VIDEO
OUT
DC IN 12V
AUDIO
OUT
Note: The 300/75 ohm adapter is an optional
accessory that is not supplied with the VCP
but should be available from your Zenith
video product retailer.
VIDEO
OUT
DC IN 12V
AUDIO
OUT
2.
Figure 2a: Antenna Connection
ANT.IN
3
4
CHANNEL
RF.OUT
Figure 2b: Cable-TV Connection
ANT.IN
3
4
CHANNEL
RF.OUT
I N S TA L L AT I O N
Connect the antenna or cable-TV line to
the ANT IN terminal on the VCP.
300/75 ohm
Adapter
Flat Wire
or
Round Wire
Turn off power or unplug VCP
before making any connections.
CH 3/4
Output
DECODER/
CONVERTER
or
(Direct Connection)
P A G E 7
CABLE-TV
Advertisement
Table of Contents
