Table of Contents
Advertisement
Overview
The HHPS01 wireless controller can control an
unlimited number products provided they are
within range. To do this, the controller must be
paired with each heater. The heater will not
operate until it has been paired to the
controller.
Pairing the heater to the HHPS01
In order to pair your appliance with the controller
you must:
• Ensure power to the appliance is OFF.
• Set the heater fan switch to ON.
• Turn the power to the appliance ON.
• Within 20 seconds, press and hold the PROG
and MODE buttons on the controller until the
display shows 'PAIR'
• The fan should run and the appliance ready to
be used.
Basic operation
The HHPS01 also has a STANDBY MODE. To
enter/exit this mode, press the standby button.
In STANDBY MODE, the heating will not be
activated and the display will be blank.
The HHPS01 has 4 standard operating modes:
BOOST, MANUAL, FROST PROTECT and AUTO.
Each mode can be selected by pressing the MODE
button to cycle through the options. The cycle
sequence will always start with BOOST mode
followed by MANUAL, FROST PROTECTION and
AUTO.
The HHPS01 also has two special operating
modes. These are MANUAL CONTROL MODE
and LOCAL TEMPERATURE CONTROL MODE.
These are accessed via setup menu.
To adjust the operating mode/settings of the
HHPS01, the display must first be activated. If the
controller is in STANDBY MODE, press the power
button. The controller will exit standby mode and
the display will be activated for 10 seconds. If the
controller is not in STANDBY MODE, press any of
the TIME, TEMP or MODE buttons once. The
display will be activated for 10 seconds.
4 | SmithsEP.co.uk | Issue 003 - March 2024
Advertisement
Table of Contents
