Table of Contents
Advertisement
Step 8: Press the PROG
button. The temperature
should flash. Use the
+ and - buttons to
select a frost protection
temperature.
Step 9: Repeat these
steps for programs
3-6 if additional time
periods are required.
Any programs not
being utilized must be
deactivated. To do this,
simply select the program
in question as per step
6 and press the TIME
button. The time should
change to dashes as
shown below. To
reactivate the program,
simply press the TIME
button again.
Automatic program overview
The HHPS01 has a 7-day, 5-day 2-day and a 24
hour timer available. This can be chosen in the
setup menu. Up to 6 programming steps are
available for each day. In the programming you
can set a start time and a temperature for each
program.
Basic operation
1. Press and hold PROG for 5 seconds to enter
the program setting.
2. The day will be flashing. Use + and - to
navigate day, press PROG to select day.
3. PROG 1 will be flashing. Use + and - to
navigate program, use PROG to select
program.
4. The time will be flashing. To set time, use +
and - , press PROG to set the time.
5. The temperature will be flashing. To set
temperature, use + and - to change
temperature, press PROG to set temperature.
To add another program repeat steps 2-10.
8 | SmithsEP.co.uk | Issue 003 - March 2024
Set program inactive
If you do not require the use of all 6 programs
they can be deactivated. When in programming
mode select the program you want to make
inactive and press the TIME button. To activate the
program again, press the TIME button.
Copy day function
If you require the same set of programs
throughout the week, a 24 hour timer is available.
This will use the same program every day. A 5-day
+ 2-day timer is also available. This will use the
same programs Monday-Friday, and the same
programs Saturday and Sunday. These modes are
enabled in the setup menu, as explained on page
9.
Alternatively, it is possible to copy a program from
one day to another. To do this, follow the steps
below;
Step 1: Press and hold
PROG for 5 seconds
to enter the program
setting.
Step 2: Press and hold
TIME for 5 seconds
to enter the copy day
setting.
Step 3: Use the PROG
button to select the day
to copy the programs
from. 1= Monday, 2 =
Tuesday and so on.
Advertisement
Table of Contents
