Table of Contents
Advertisement
B - Program mode
select.
Choose between a 7-day,
5-day 2-day or a 24 hour
timer.
C - Select operating
mode:
1 = temperature control
2 = manual control
D - Enable/disable SL
wireless signal
E - Compatibility
modes:
0 = Normal operation
Choosing a position in a room
When using the HHPS01 for temperature control,
a suitable position in the room should be chosen.
Avoid areas with draught or direct sun. Do not
position HHPS01 above or close to the heaters or
other heat sources. Damp areas or areas where
HHPS01 can be mechanically damaged should also
be avoided. Typically 1.2 to 1.5m above floor level.
Installing the controller
The controller can be left free-standing or
mounted to the wall in a suitable location.
To mount the controller to the wall, the supplied
wall bracket should be used. Install the bracket
using the 2 screw holes provided as shown in the
image.
10 | SmithsEP.co.uk | Issue 003 - March 2024
The bracket acts
as a holder for
the controller. The
controller can be
removed from the
bracket easily to
operate as a handheld
device. Alternatively,
a locking screw can
be attached from the
bottom of the device
to permanently fix
the controller to the
bracket.
Batteries
The HHPS01 is battery powered. Remove the
battery cover and insert 2 new high quality
alkaline AA batteries.
Warning: Smith's is not responsible for damage
due to corrosion. Battery leakage will cause
permanent damage.
To help avoid battery leak:
• Replace the batteries annually, even if there is
not a low battery warning. Remove failing or
flat batteries immediately.
• Always fit new high quality alkaline batteries
from the same pack. Never mix new and old
batteries, or batteries of different brands or
types.
• Never attempt to revive alkaline batteries by
heating, crushing or recharging.
Note: The clock has to be reset after replacing
the batteries. The program settings will be
remembered.
Advertisement
Table of Contents
