Antenna/Cable Connections - Zenith L15V26D Installation, Setup & Operating Manual

Antenna/Cable Connections

- For optimum picture quality, adjust antenna direction.
Connecting to an Inside
Connecting to an Inside
Typical wall antenna jack used in apartment buildings, connect the antenna cable as shown below.
(Use the correct type of antenna cable for the type of wall antenna jack.)
Apartment Buildings
- If you have a 75
nut. If you have a 300
then connect the converter to the antenna jack on the TV.
- When using 75
picture quality.
Connecting to an Outdoor
Connecting to an Outdoor
This type of antenna is commonly used in single family dwellings.
Single Family Home
- In poor signal areas, to get better
picture quality, install the antenna as
shown to the right.
- If antenna is split for two TVs, use
signal splitter for connection.
Antenna Setup
Antenna Setup
75 Round Cable
300
Wall Connection Jack
round cable, insert the bronze wire and then tighten the connection
flat wire, connect the twisted wire to the antenna converter and
round cable, do not bend the bronze wire. Doing so may cause poor
Antenna Setup
Antenna Setup
VHF Antenna
75
UHF
Antenna
300
Turn clockwise to
tighten.
Bronze Wire
Flat Wire
Antenna
Converter
Turn clockwise to
tighten.
Round Cable
Bronze Wire
Flat Wire
Antenna
Converter
VHF
UHF
Signal
Amplifier
PC INPUT ANT IN PC
SOUND
+75
Antenna jack
PC INPUT ANT IN PC
SOUND
+75
Antenna jack
PC INPUT ANT IN PC
SOUND
+75
13