Table of Contents
Advertisement
en Drying
17.2 Wiping down the cooking compartment
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
▶
After using the cleaning assistance, wipe the cook-
ing compartment and allow it to dry completely.
Requirement: The cooking compartment must have
cooled down.
1.
Open the appliance door and remove the remaining
water with an absorbent sponge cloth.
18 Drying
To prevent residual moisture, dry the cooking compart-
ment following operation.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
▶
Do not use the appliance if there is water on the
cooking compartment floor.
▶
Wipe away any water on the cooking compartment
floor before operation.
18.1 Drying the cooking compartment
You can dry the cooking compartment by hand or use
the drying function.
1.
Allow the appliance to cool down.
2.
Remove dirt from the cooking compartment.
3.
Wipe away the water in the cooking compartment.
4.
Dry the cooking compartment.
Leave the appliance door open for one hour to
‒
dry the cooking compartment by hand.
19 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
19.1 Removing the door cover
The stainless steel inlay in the door cover may discol-
our. Remove the door cover in order to clean it and the
stainless steel inlay, or to remove the door panes.
1.
Open the appliance door slightly.
2.
Press down on the left- and right-hand sides of the
door cover.
24
2.
Clean the smooth surfaces in the cooking compart-
ment with a dish cloth or a soft brush. Remove stub-
born food remnants using a stainless steel scouring
pad.
3.
Remove limescale with a cloth soaked in vinegar.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
4.
In order to dry the cooking compartment, leave the
appliance door open in the detent position (approx.
30°) for approx. one hour.
In order to use the drying function, set the drying
‒
function.
→ "Setting the drying process", Page 24
Setting the drying process
1.
Allow the appliance to cool down.
2.
Remove coarse dirt from the cooking compartment
and wipe away moisture from the cooking compart-
ment floor.
3.
Press
.
4.
In the operating mode menu, press the drying oper-
ating mode.
The duration is set to 10:00 min. and cannot be
changed.
5.
Press
to start the drying function.
a The appliance starts to dry and the duration counts
down.
6.
Once the duration has elapsed:
A message appears in the display.
‒
Press
to silence the audible signal before
‒
it is due to end.
Press
to switch the appliance off.
‒
3.
Remove the door cover and carefully close the ap-
pliance door.
Advertisement
Table of Contents
