Table of Contents
Advertisement
II-2.
Connection
1. Power on: Connect the power cord to the switch and the power outlet.
The switch is powered by the 100-240VAC 50/60Hz external high-
performance power supply. (Note: Make sure the PWR LED is green.)
2. Uplink: Plug the standard Cat5e or above Ethernet cable into the LAN port
(Note: Make sure that the LED is green or amber) or plug the SFP/SFP+
cable into the SFP/SFP+ slot (Note: Make sure that the LED is blue (SFP+)
or green (SFP)) and connect it to another switch.
3. Connect devices: Plug the standard Cat5e or above Ethernet cable into the
LAN port and connect to any networking device with an Ethernet port.
(Note: Make sure that the "LAN" Link/Act LED is green or amber.) The
hardware installation is complete!
4. Connect a computer: Connect your computer with the switch and get
ready for web-based configuration with following ＂Section III
Web-based Configuration Utility＂.
4. Connect to
a computer
1. Power on
3. Connect devices
2. Uplink to another
6
switch
Advertisement
Table of Contents
