Setting And Starting A Washing Programme - Electrolux GA60GLV401 User Manual

• Press the multitab button. The multitab in-
dicator light comes on.
To deactivate the multitab function:
• Press the multitab button. The multitab in-
dicator light goes off.
Do these steps if the drying results
are not satisfactory:
1. Fill the rinse aid dispenser with rinse
aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• You can only activate or deactivate
the rinse aid dispenser when the mul-
titab function is activated.
To activate/deactivate the rinse aid dispens-
er:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons
A, B, and C start to flash.
4. Release function buttons B and C.
5. Press function button B.

Setting and starting a washing programme

Important! Set the options before the start
of a washing programme. You cannot set an
option when a washing programme
operates. If it is necessary to set an option,
cancel the washing programme.
Set the washing programme with the
door ajar. The washing programme only
starts after you close the door. Until then
it is possible to modify the settings.
Do these steps to set and start a washing
programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press one of the programme selection
buttons. Refer to the chapter 'Washing
programmes'.
– The programme number shows in the
digital display.
4. Close the door.
– The washing programme starts.
– The indicator lights for function buttons
A and C go off.
– The indicator light for function button B
continues to flash.
– The digital display shows the setting.
6. Press function button B again.
– The digital display shows the new set-
ting.
7. Switch off the appliance to save the op-
eration.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting to
the highest level.
4. Do a washing programme without
dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the rinse aid dosage.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.
Warning! Only interrupt or cancel a
washing programme if necessary.
Caution! Open the door carefully. Hot
steam can come free.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point
of interruption.
Cancelling a washing programme
1. Press and hold the cancel button until the
digital display shows two horizontal bars.
After you cancel the programme, you can:
1. Switch off the appliance.
2. Set a new washing programme .
electrolux 13
Rinse aid dispenser de-
activated
Rinse aid dispenser ac-
tivated