2 SETUP
4
–
Together with an assistant, take the vehicle off the pallet.
–
Position the vehicle on a lift stand.
–
Check the vehicle for transport damage.
Info
The procedure in the event of transport damage is
described in the Customer Service Manual.
H01079-01
–
Remove screws
–
Remove screws
–
Place the handlebar support in the required position.
Info
The handlebar support is longer and higher on one side.
–
Mount and tighten screws
Guideline
Screw, handle-
bar support
S05484-10
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged
or bent.
S05475-10
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
Do not kink the cables or lines.
–
Position the handlebar clamp.
Info
The markings on the handlebar should be at the center
of the handlebar clamp.
–
Mount screws
3
. Take off the handlebar clamp.
4
. Take off the handlebar support.
4
.
M10
40 Nm (29.5 lbf ft)
3
, but do not tighten yet.
Loctite
®
243™