3.3.3 Unpacking the unit
To unpack the unit proceed as follows:
Carefully remove the upper and side structures of the packaging crate, then remove the lower
•
panel and the installation kit components supplied with the unit.
•
Remove the coatings and accessories of the unit present
•
Attach the unit, using the two brackets (1, Figure 21), to a suitable lifting device and lift it slightly.
1
•
Remove the screws that fix the unit to the packaging crate.
Remove the two rear stations of the packaging crate and lift the unit from the base at a height of
•
about 300 mm [11.81 in].
Remove the four mounting bolts that fix the two vertical columns to the unit.
•
The unit is ready to be installed.
24
-
INSTALLATION MANUAL
Figure 21 - Anchor brackets
Refrigeration unit
Series Uno
U600 | U800 | U1000
U800 Multi | U1000 Multi
1
rev.03