Table of Contents
Advertisement
CONTROLS AND OPERATIONS
Installation
Exhausting hot air
When use the appliance in cool mode, the hot air exchange of the condenser must be exhausted
out of the room completely.
First position unit on a at oor and make sure there's a minimum of 18"(45cm) clearance
around the unit, and is within the vicinity of a single circuit outlet power source.
1.
Extend either side of the hose (Fig.1), and screw the hose inlet (Fig.2).
2.
Extend the other side of the hose and screw it to the hose outlet (Fig.3).
3.
Install the hose inlet into the unit (Fig.4).
4.
A x the hose outlet into the window slider kit and seal. (Fig.5 &6).
Extend the side of the hose
•
The window slider kit has been designed to t most standard vertical and horizontal
window applications,however, it may be necessary for you to modify some aspects of the
installation procedures for certain types of windows. The window slider kit can be fastened
with screws.
Note:
•
If the window opening is less than the minimum length of the window slider kit, cut the
end without the hold in it short enough to
t in the window opening.
Never cut out the hole in window slider kit.
Fig. 1
Fig. 2
Fig. 3
Cut on the opposite side of the hole.
4
Fig. 4
Advertisement
Table of Contents
