Mistral MAS101 Operating Instructions Manual

Reverse cycle split system air conditioner

Advertisement

������� �����
����� ������
��� �����������
MAS101 - 1 HP
MAS151 - 1.5 HP
MAS201 - 2 HP
MAS201SS - 2 HP
by
�����
� � �
� � � �

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MAS101 and is the answer not in the manual?

Questions and answers

Summary of Contents for Mistral MAS101

  • Page 1 ������� ����� ����� ������ ��� ����������� MAS101 - 1 HP MAS151 - 1.5 HP MAS201 - 2 HP MAS201SS - 2 HP ����� � � � � � � �...
  • Page 2: Important Safeguards

    Important Safeguards When using electrical appliances, in order to NOTE : reduce the risk of fi re, electric shock, and/or injury to persons, basic safety precautions For proper performance, operate the unit under should be followed, including: the usable operating temperature and humidity conditions indicated in this owner’s manual.
  • Page 3: Getting To Know Your Air Conditioner

    Congratulations on the purchase of your new Split System Air Conditioner. Before the fi rst use of your new Mistral unit, it is most important that you read and follow the instructions in this Use & Care booklet, even if you feel you are quite familiar with this type of appliance.
  • Page 4 Indoor Unit ������ ����� ����� ��� ����� ����� ���� ����� � � � � � � � ���� � ����� � ������� ������ ���������� ������ ��������� ����� ��� ����� ������ ����� ������ ���� ��������� ���� ��������� ��������� ��������� ����� ��������� �����...
  • Page 5: Remote Controller

    Remote Controller ������ �������� ������ ��������� ������� ����� ������ ������ ����� ������ ��������� ���� ������ ���� ��� ������ ����������� ���� �� ������ ���������� ������ ���� ������ ������ ������ ������ ���� ��� ������ ��� ����� ������ ����� ������ Battery Compartment • Ensure batteries are inserted in the correct direction.
  • Page 6: Remote Control Preparation

    Remote Control Operation of Air Preparation Conditioner Operating procedure using the Remote control 1. Start/Stop or On/Off • Press I/O button to start operation, the unit will stop when repressed. 2. Temperature adjustment • Press TEMPERATURE ADJUSTMENT button, decreases by 1˚C by pressing “ decreases by 1˚C by pressing “...
  • Page 7 SLEEP R U N T I ME Fig 1 ADVICE • In DRY or COOL mode, ensure the Fan speed is set to set to set to set to set to (auto), air blows downward in (auto), air blows downward in (auto), air blows downward in (auto), air blows downward in (auto), air blows downward in...
  • Page 8 Operating procedure- 2 COOL mode Press MANUAL SWING button or SWING button control under the to change up/down air fl ow direction. Press FAN SPEED button to change the fan speed of indoor Emergency operation unit. Press TEMPERATURE ADJUSTMENT button switch to change the temperature setting.
  • Page 9: Service And Maintenance

    Service and Maintenance WARNING Before you clean the air conditioner, be sure to disconnect the power supply plug. Cleaning the indoor unit and the remote controller CAUTIONS • Use a dry cloth to wipe the indoor unit and remote controller. •...
  • Page 10 Filters must be cleaned on a regular basis FILTERS SHOULD BE CLEANED ONCE CLEAN DEODORIZATION FILTERS AND EVERY TWO WEEKS AIR CLEANER 1. Take out fi lters 1. Take out fi lters fi rst, then take out deodorization fi lter and air cleaner. 2.
  • Page 11: Fault Confi Rmation And Analysis

    Fault Confi rmation and Analysis If problems persist after performing the tests below, please stop the air conditioner and If problems persist after performing the tests below, please stop the air conditioner and contact our service centre nearest to you to get help. Fault Fault analysis Air conditioner does not operate at all.
  • Page 12: Performance Parameters

    Performance Parameters ������ � ��� ������ � ����� ����� ������ ������� ������ ������� �������� ���� ���� ���� ���� ���� ���� ����� ���������� ���� ���������� ���� ����� ��������������� �������� ��� ��������� ��������� �������� ����� ����� ��� ������������������� ��������������������� �������� ����� ������� ��� �������������������...
  • Page 13 Performance Parameters (Cont.) ��������������� � ��� ����� ������ ������� �������� ���� ���� ���� ����� ���������� ���� ����� ��������������� �������� ��� ��������������������� �������� ����� ����� ��� ��������������������� �������� ����� ������� ��� ������������������� ��� ������������� �������� ����� ��� ���������� � ����������� ���� ����...
  • Page 14: Installation Sketch

    Installation Sketch ���� ��� ������ �� ������ ���� ������������ ������ ������� �� ��� ��� ��� ����� ���� ������ ���� ��� ������� ������������ �� ��� ����� ������ ���������� �� ��������� ���� ����� ���������� ���� ���� �������������� ��������� ��� ��������� �� �������������� ��������...
  • Page 15: Installation Accessories

    Installation Accessories Before installation, inspect the following accessories: ������ ���� ����������� �������� ������������ ����������� �������� � �������� ����� � � ���������� ���� � � ������� ����� ��� � �� � � ������� ���� � � ��������� ������ ���� � � �����...
  • Page 16: Installation

    Installation 1. Secure the mounting plate • The mounting plate should be attached to the structural part of wall (post etc.) ����� � ����� ��������� �� ����� ������ ���� �� ������� �� ����� �������� ����� ������� � ���� ��� ��������� ����� ��� ����� ��� ����� ������ �� ������ ����� ����� ������...
  • Page 17: Outdoor Unit

    OUTDOOR UNIT OUTDOOR UNIT �������� � ��� ���������� ������ ���� �� ������� ��������� � ������� ����� ���� �� ���� �� ������� ������ ���� ��� ������� ����� ������ ���� ��� � �� �� ���������� ����� ��� ����� ������� �� ���� �� ��������� �...
  • Page 18: Installation Of Indoor Unit

    INSTALLATION OF INDOOR UNIT • Let pipe go through the wall hole and attach the indoor unit to the mounting plate. (Locate the rib of the indoor unit in the hole of the mounting plate.) THE CONNECTION OF PIPE • The number of bends in the pipe of the indoor unit should not exceed 10.
  • Page 19: Add Refrigerant

    INSTALL THE DRAIN JOINT (heat pump type only) • Install the double-channel drain joint in the hole on the bottom of the outdoor unit’s bottom, then connect drain hose and joint. CONNECT CONNECTING PIPE • Wipe the air sealing oil on the closing valve and the trump extended pipe;...
  • Page 20: Warranty Conditions

    RINGGRIP (NZ) Pty Ltd ACN 006 771 922 PO Box 33672, Takapuna, Auckland NZ Mistral is a registered trademark of Mistral International Pty Ltd. ©2001 Linda Australia Pty Ltd After sales and service support (includes installation) is provided by: Electric Blue Installations & Service Pty Ltd...

This manual is also suitable for:

Mas151Mas201Mas201ss

Table of Contents