Related Manuals for Mistral MSS10
Summary of Contents for Mistral MSS10
- Page 1 Reverse Cycle Split System Air Conditioner MSS10 - 1HP MSS15 - 1.5HP MSS20 - 2HP MSS25 - 2.5HP ...
- Page 2 Split System Air Conditioner. the power outlet. Never pull cord. Before the first use of your new Mistral unit, Deflector Left / Right deflector it is most important that you read and follow Do not operate any appliance with a damaged ...
- Page 3 Remote Controller Remote Control Operation of Air Conditioner Preparation Operating procedure using the remote control Signal ejecting window 1. Start/Stop or On/Off • Press I/O button to start operation, OPERATION DISPLAY SWING BUTTON the unit will stop when repressed. 2. Temperature adjustment MANUAL SWING •...
- Page 4 ADVICE • In DRY or COOL mode, ensure the Fan speed is set to...
- Page 5 Service and Maintenance Filters must be cleaned on a regular basis FILTERS SHOULD BE CLEANED ONCE EVERY CLEAN DEODORIZATION FILTERS AND AIR WARNING TWO WEEKS CLEANER Before you clean the air conditioner, be sure to disconnect the power supply plug. 1.
- Page 6 Fault Confirmation and Analysis Performance Parameters n If problems persist after performing the tests below, please stop the air conditioner and MSS10 - 1HP MSS15 - 1.5HP Model contact our service centre nearest to you to get help. indoor outdoor...
- Page 7 Performance Parameters Performance Parameters (cont.) (cont.) MSS20 - 2HP MSS25 - 2.5HP Model Model indoor outdoor indoor outdoor Function heat pump type Function heat pump type Power 220-240V~, 50Hz Power 230V~, 50Hz Rated cooling/heating capacity (W) 5100(cool)/5700(heat) Rated cooling/heating capacity (W) 6800(cool)/7500(heat) Standard input power (W) 1960(cool)/2000(heat)
- Page 8 Installation Sketch Installation Accessories Before installation, inspect the following accessories: Confirm installation position Indoor unit accessories Quantity Installation accessories Quantity with the marker of indoor unit installation board. Mounting plate Connecting pipe Tapping screw ST4 x 25 Bonding tape Expansion rubber plug Clamp Expansion bolt Cement nail...
- Page 9 Installation ¢ OUTDOOR UNIT 1. Secure the mounting plate • The mounting plate should be attached to the structural part of wall (post etc.) WARNING: • The connecting cables must be clipped together. • Special cable must be used to connect indoor unit and outdoor unit. Ensure that the NOTE: •...
- Page 10 ¢ INSTALLATION OF INDOOR UNIT ¢ INSTALL THE DRAIN JOINT (heat pump type only) • Let pipe go through the wall hole and attach the indoor unit to the mounting plate. • Install the double-channel drain joint in the (Locate the rib of the indoor unit in the hole hole on the bottom of the outdoor unit's of the mounting plate.) bottom, then connect drain hose and joint.
- Page 11 Failure to do so will void the warranty. June 2003 Cat. No. MSS10-1HP , MSS15-1.5HP , MSS20-2HP , MSS25-2.5HP Product of Linda Australia Pty Ltd ABN 60 079 923 130 324 Frankston - Dandenong Road...