Infrared Setup; Programming - Permobil R-net LCD User Manual

2.7.5

Infrared setup

Applies to control panels equipped with integrated infrared.
A right deflection of the joystick will enter a submenu for learning and deleting
infrared codes.
See chapter 2.9 Infrared mode, page 41.
2.7.6

Programming

The following section describes submenus related to programming.
Sleep sets the time after which the control system will go
to sleep if an input device command is not received.
Sounder Volume sets the volume of the sounder used to indicate
button presses.
Horn Volume sets the volume of the horn.
Start-up Beep sets whether or not the controller emits a short
beep when turned on. Available only in later versions
of the control panel.
Momentary Screens sets whether programmed Momentary Screens are
displayed.
Display Speed sets how the wheelchair's speed is displayed;
options are mph, km/h or Off.
Displays sets the format of the digital drive display; options
are odometer, speed or both.
R-net LCD control panel - 27