ResMed AirCurve 10 ST-A Quick Start Manual page 2

Read your entire AirCurve™ 10 User Guide before use.
Setup
1
With the device on a stable level surface,
grip the retention clip on the back of the
device and pull up to open.
Note: The retention clip is shown in the open
position.
3
Connect the air tubing firmly to the air outlet
located on the rear of the device.
5
Close the water tub and insert it into the
side of the device.
288334 AirCurve 10 ST-A PQSG AMER Eng_2.indd 3-4
b
2
a
(a) Plug the power connector into the device
power inlet then (b) push down the retention
clip to secure in place.
Connect one end of the power cord into the
power supply unit and the other end into the
power outlet.
4
Open the water tub and fill with water up to
the maximum water level mark.
6
Connect the free end of the air tubing firmly
onto the assembled mask. Press Start/Stop
to begin therapy.
Adjusting to therapy
If you are a first time user, you might need some time to get used to therapy. This is not unusual as
it takes most patients between one and two weeks to adjust to the air pressure.
Overcoming symptoms by changing comfort settings
If your are having difficulties getting used to therapy, use the AirCurve 10 comfort features to help
you on your journey to better sleep.
• Dry or runny nose—If you are getting a dry or runny nose, adjust the Humidity Level by turning
it up.
• Droplets of water (condensation)—If you are getting droplets of water on your nose, mask or air
tubing, adjust the Humidity Level by turning it down.
To change the Ramp Time:
2. Turn the dial to
1. Press the dial to
highlight Ramp
enter My Options.
Time and then
press to select it.
Cleaning
1. Wash the water tub and air tubing in warm water using mild detergent.
Do not wash in a dishwasher or washing machine.
2. Rinse the water tub and air tubing thoroughly and allow to dry out of direct sunlight and/or heat.
3. Wipe the exterior of the device with a dry cloth.
Refer to your mask User Guide for detailed instructions on cleaning your mask.
4. Press the dial to
3. Turn the dial
to adjust to your save the change.
preferred setting.
23/11/2015 10:51:52 AM