Table of Contents
Advertisement
7. Turn the chemical dispensing valve to the left to-
ward the word "SOAP".
8. Chemical will draw Accurately only in the "LOW"
pressure setting of your pressure gun. To activate the
"LOW" pressure, pop the collar of the gun out.
9. In "LOW" pressure, apply chemical to the walls and
fixtures starting from the lowest point to the highest.
10. Spray the floor as you make your way out of the
room.
11. Allow the chemical to dwell according to the chemi-
cal manufacturers recommendations.
12. You may use the brush on your squeegee/brush wand
to agitate particularly soiled areas.
13. When you are ready to rinse away the chemical, sim-
ply turn the chemical dispensing valve (#11 on page
7) to the word "RINSE".
14. Set your pressure gun to the desired pressure and
angle of spray by adjusting the collar. Rinse surfaces
starting from the top down.
15. See "Recovering liquid" for final steps.
RECOVERING LIQUID FROM HARD SUR-
FACES:
The CR2 JR is equipped with two dedicated tools for liq-
uid recovery: The squeegee/brush wand and the Gulper
tool.
1. Connect recovery vacuum hose to the recovery inlet
barb.
2. Place the vacuum switch into the "ON" position.
3. Using either the squeegee/brush wand or the Gulper
tool, to extract the liquid from the surface.
4. Monitor the levels in the recovery tank and empty
as necessary. Use defoamer to ensure your vacuum
motor does not take in foam/fluid.
extraction as it will restrict suction.
CLEANING CARPET OR UPHOLSTERY:
The CR2 JR can be used as a non-heated carpet ex-
tractor.
1. Prespray the area of carpet to be cleaned
2. Connect your solution line
3. Connect your recovery vacuum hose
4. Connect your wand or upholstery tool to the solu-
tion and vacuum hoses
5. Fill the solution tank of your CR2 JR with water
6. Make sure Chemical Dispensing Valve is in the
"RINSE" position
7. Place the pump switch into the "ON" position
8. If necessary, allow pump to prime for 10-30 seconds
by turning the priming/pressure relief valve 45 de-
grees to the left to the "O" open position.
9. Allow pump to prime
10. Close the Priming valve
11. Turn on the vacuum motor
12. Spray on the backstroke and do a dry stroke when
pushing forward.
13. Overlap your previous path slightly when you pull
back
14. Monitor the levels in the recovery tank and empty
as necessary. Use defoamer to ensure your vacuum
motor does not take in fluid
NOTE: The CR2 JR Chemical system does not apply
chemical in carpet mode. You may use traditional in-
tank or prespray methods.
USING THE BLOWER FEATURE:
To use, this feature connect the Blower hose to the Blow
Hose Connector and turn on the vacuum motor.
Convenient for:
•
Blowing fluid off countertops and walls onto the
floor
•
Drying faucets and other fixtures
•
Blowing off dust
NOTE: Do not leave the blower hose on during normal
11
Advertisement
Table of Contents
