Sunny MEL Series User Manual

USER MANUAL
Self-Contained Emergency Light MEL Series

Installation and Operation

1 . Model MEL209CD3 is designed to be install on level surface or hung on a wall.
2. Install properly and securely to prevent accidents that could cause damage to the unit or
other people and property.
3. Pressing the ON switch will turn on both lamps.
4. The LED on the unit indicates the following.
- LED LDR ON is continuously on indicates that the unit is operational
- LED LDR ON is blinking indicates that the Light Detector function is being used.
5. Plug the unit into a 220-240VAC mains power socket. The lamp should illuminate for about
5 seconds beforeturning off. The orange AC LED should be on to indicate the unit is receiving
power. The red Charge/Full LED should be off indicating that the battery is fully charged.
6. To use the Light Detector function, press the LDR ON switch located on the side of the unit.
- If the Light Detector function is being used, during power outages the unit will check if the
area within its vicinity has less than 5 Lux of illumination. If the surrounding area is brighter
than 5 Lux theunit will not turn on and conserve its battery for when it is more needed.
- If the Light Detector function is not being used the unit's lamp will turn on as soon as there
is a power outage regardless of how bright the surrounding area is.
Caution: Please always read the manual prior to installation and operation.
On
LDR On/Off
Test
1