Sunny CU Series User Manual

USER MANUAL
Self-Contained Emergency Light CU Series
Features
1. Controlled by a highly intelligent 8-bit micro controller.
2. Automatically self-test every 30 days and discharges the battery for 30 minutes to
help extend the life of the battery.
3. Testing can be activated remotely using the infrared remote.
4. Using high quality LEDs with a lifetime of over 50,000 hours, providing bright and
constant illimitation throughout its operation.
5. The unit's outer case is made from ABS UL94 V-0 Flame Retardant plastic that is
highly resistant to impact and corrosion.
6. The battery monitoring circuit will give an audible warning when the battery's charge
is about to be depleted, giving the user time to recharge it before draining
completely. This will help to extend the life of the battery.
LED AC. indicate that the unit is receiving power.
LED Charge/Full gives information on battery charging.
LED On indicate the unit is ready for operation.
LED 5 sec indicate the unit is performing a 5 second test.
LED 30 mins indicate the unit is performing a 30-minute test.
LED 60 mins indicate the unit is performing a 60-minute test.
Switch On press to turn on the lamp (while the unit is not plugged in).
Switch Off press to turn off the lamp (while the unit is not plugged in).
IR receiver infrared signal sensor used to receive signal from the
infrared remote.
Status Indicators and Testing Buttons
Remote Testing
5 30 60
secs mins mins
Remote Testing