Table of Contents
Advertisement
I Rear Panel
@4
@4 Power Switch (STAND-BY ON/OFF)
Power switch for the main unit.
* To protect the speakers, set the OUTPUT knob
before switching the power ON/OFF.
@5 Power Adaptor Jack (AC IN 12V 1A)
Connect the supplied power adaptor to this jack.
* Never use a power adaptor other than the supplied adaptor.
Use of any other power adaptor may cause damage, over-
heating, fire, etc.
@6 MIDI OUT Jack
This jack is used for transmitting MIDI data from the
UD-Stomp such as control changes, program
changes, data in the UD-Stomp's memory, etc. (→
page 26).
@7 MIDI IN Jack
This jack is used for receiving MIDI data from a MIDI
device, such as a MIDI foot controller, that can be
used to select patches, volume, or control each of
the effects in the UD-Stomp. (→ page 20)
Also, UD-Stomp memory data saved to an external
MIDI device can be returned to the UD-Stomp via
this jack. (→ page 26)
@8 DIGITAL OUT Jack
This Jack is used for sending the output of the UD-
Stomp as digital data.
Connect to a device equipped with a digital input
jack (COAXIAL) such as a digital mixer, etc. (→ page
11).
@5
@6
@7
@1
to "0"
@8
@9
#0
@9 Expression Pedal Jack (EXP. PEDAL)
This jack is used to connect a foot controller (ex-
pression pedal) (optional) such as a Yamaha FC-7
to control individual UD-Stomp parameters. (→ page
24, 26, 27).
#0 Headphones Jack (PHONES)
Connect a pair of headphones (optional) to this jack
for private practice or practicing at night when you
don't want to disturb others. (→ page 11).
* Even when headphones are used, the audio signal is
delivered from the OUTPUT jack
@8
OUT jack
.
#1 Output Jacks (OUTPUT R, L/MONO)
The analog output jacks for the UD-Stomp. Con-
nect these jacks to the input jack on a power ampli-
fier + speaker set or guitar amp, mixer, etc. (→ page
10)
* Use the L/MONO jack when connecting to a monaural de-
vice.
#2 Input Level Switch (LOW/HIGH)
#3 INPUT Jack
This is the UD-Stomp's input jack. Connect a guitar
or other electric musical instrument to this jack. Se-
lect either HIGH or LOW to match UD-Stomp's in-
put jack to the output level of the instrument con-
nected to the jack.
* Make sure the power is switched OFF before connecting the
instrument.
Nomenclature
#2
#3
#1
#1
and the DIGITAL
9
Hide quick links:
Advertisement
Table of Contents
