Ahuja XDA-7002 Operation Manual page 9

Mono Mode Configuration
Wireless Microphone
Speaker System
When operating in MONO mode, the signal source should be connected to the balanced / unbalanced input of
channel A only. Both channels provide similar output to their respective loudspeakers. Each channel can
separately drive loudspeaker loads of 8/4 ohms.
n Connect the line output of a mixer to channel A
input of the amplifier. Input can be wired as per fig.
1 & 2 (Input Connections for Balanced and
Unbalanced Mode).
n
Connect a speaker system on the output terminal
of each channel. It is recommended to use the
speakon connectors and wire these as per fig. 3
(Output Connections for Stereo / Mono Mode).
n
To select MONO mode, keep the slide switch,
provided at rear panel, in MONO position.
Microphones
Line Output
Play Input
PA Mixer
CH. A Input CH. A Input
CH. B Input
9
• Setup & Operations...
CD Player
XDA-7002
n The desired output levels of the A & B channels are
adjustable by individual control of channel A & B
respectively.
n
The signal indicator LEDs glow to indicate the
presence of signal.
n Operate the amplifier below the onset of clip LED
glow. Continuous clip LED glow may push amplifier
into protect mode.
Speaker System
XDA-7002