Table of Contents
Advertisement
• Setup & Operations
Stereo Mode Configuration
Wireless Microphone
Speaker System
In STEREO mode, both channels A & B are fully independent of each other. The balanced / unbalanced inputs
can be connected either to a stereo signal source or two independent mono signal sources. Each channel can
separately drive loudspeaker loads of 8/4 ohms.
n
Connect the Left and Right outputs of a mixer to
channel A and B inputs of the amplifier
respectively. Inputs can be wired as per fig. 1 & 2
(Input Connections for Balanced and Unbalanced
Mode).
n
Connect a speaker system on the output terminal
of each channel. It is recommended to use the
speakon connectors and wire these as per fig. 3
(Output Connections for Stereo / Mono Mode).
n
To select STEREO mode, keep the slide switch,
provided at rear panel, in STEREO position.
XDA-7002
Microphones
Line Output
L
R
AMX-1412
PA Mixer
CH. B Input
8
CD Player
CH. A Input
XDA-7002
n
Adjust the individual volume controls of each
channel on the front panel to obtain the desired
output level.
n
The signal indicator LEDs glow to indicate the
presence of signal at the output terminals.
n
Adjust the input signal level below the threshold of
clip LED glow.
Speaker System
Advertisement
Table of Contents
