Trouble Shooting - Ahuja XDA-7002 Operation Manual

19" Rack Installation
n
The amplifier is designed for use in a standard
19"rack with height of 2U units.
n
In order to provide sufficient support base to the
heavy amplifier, it is essential to use the 19" rack
system with side support channels.
n
The installed amplifier, should be well supported by
the side support channels as well as rigidly fixed
on to the rack through the two rack mount side
brackets duly fitted with 'U' type handles, as shown
in the figure below:

• Trouble Shooting

Indication:
ON PROTECT
GREEN GREEN
TEMP
CLIP
SIGNAL
Indication:
FAULT PROTECT
ORANGE
TEMP
CLIP
SIGNAL
XDA-7002
Table Top Usage
n
Side Support Channel
Key to LED symbols:
GLOWING BLINKING
Condition: Normal operation
Possible Reason:
The amplifier is in normal operation (When signal is fed).
+
Condition: No Power to the Amplifier
Possible Reason:
Amplifier is in over voltage protection mode.
n
The Amplifier is in fulat mode due to which DC fuse have been blown OFF.
n
An amplifier which keeps shutting off may have a serious internal fault. Turn it off,
n
remove AC power cord and get the amplifier serviced by a qualified technician.
14
The 'U' handles are helpful in easy portability of the
amplifier for table top usage. Do not keep the set
on an unstable stand or tripod.
OFF