Table of Contents
Advertisement
Available languages
Available languages
Before
use
a.
Open the battery
cover. (Push the
cover in the
direction of the
"Y" mark,
then lift.)
Insert the batteries
observing the correct
polarities (® , ©).
Transmission
window
About 7 meters (23 feet) in front
of the signal sensor. (The actual
range will depend on the angle
at which the remote control is
used.)
Please check and identify the supplied acces-
sories.
[A go AC power supply cord (SJA175-A) ................. 1 pe.
Ej [_] Stereo connection cables (RJL2P004B08)
............ 2 pes.
go Monaural connection cables (RJL1P021B08)
......... 2 pes.
B) [| Optical-fiber cable (SJP2281) ...................... 1 pe.
[eal] benes nn en ten
2 pcs.
C] Remote control transmitter (EUR644378) ............ 1 pe.
Use numbers indicated in parentheses when asking for replacement
parts.
(Only for U.S.A.)
To order accessories call PASC Accessory Dept. 1-800-332-5368.
Concerning the remote control
Battery installation
eThoroughly clean the battery compartment before inserting new
batteries.
Do not mix old and new batteries, or batteries of different types
{carbon and alkaline, etc.}.
elf you will not use the remote control for a long period of time,
remove the batteries and store them in a cool, dark place.
e Do not use rechargeable type batteries.
è Do not attempt to recharge alkaline or carbon batteries.
è Always remove old, weak or worn-out batteries promptly and dis-
pose of them properly.
e Never subject batteries to excessive heat or flame; do not attempt to
disassemble them; and be sure they are not short-circuited.
elf the leaking electrolyte comes into contact with skin or clothes,
flush with water immediately.
Battery life
Battery life is about one year.
The batteries should be replaced if the system fails to respond to
commands from the remote control transmitter even when held close
to the remote control signal sensor.
When you need to replace these batteries
Use two R6/LR6, AA, UM-3 batteries.
Method for use
|
Be sure the transmission window and the signal sensor are free from
dust. Excessive dust might affect performance.
The operation may not be correct if direct sunlight or another strong
light source strikes the signal sensor of this unit. If there is a problem,
place the unit away from the light source.
Advertisement
Table of Contents
