Roland HP 1300e Owner's Manual page 4

Assembling the KS-1300e Stand for the HP-1300e/HP-1600e ——_
Thank you for purchasing the Roland KS-1300e/1600e piano stand.
To ensure long and trouble-free use, please read this instruction sheet carefully before assembly.
8 Check the parta
¿OBafore you begin ussembiy, ci
that you have sli the parts.
Side board (left) >
Side board (right)
Pedal board-
Center board
L
Long screws (M6 x 54 mm) -
Short screws (M4 x 27 mm) «
Knob boits---
Plus screwdriver-
Cable clamps»
Na
66900 0000
@ Assembly procedure v
`
IN Attach tho side boards (left and right) to the pedal board.
xr Extand the pedal cable out from the pedal board.
(Note) Be sure that the side boards are oriented
correctly: she mesal fittings are on the inside.
Fasten the pedal cabie with the cable clamps, and plug
in the power cable and pedal cable.
The metal fittings on the inside.
Pedal cable.
(D Use the long scrows
{MB x $4 mm) to lastan the
side boards to the pedal
board.
usa two scrows for =)
aida.
® Affix the cable camps on the back left side of the stand.
Fasten the pedal cable with the cable clamps,
© Insert tho padal cable into the pedal jack on the back panel
of the plano.
O Connect the power cable into the AC inlet on tho back
panei of the piano.
Tha power cable is included with the piano.
® Use tho short screws (MA x 27 mm) % When you finish assembling the stand, rotate tho adjusting bolt until it
to attach the center board to the touches tho floor.
side boards, .
[use two seraws tor each sido. }
(Note) Ifthe piano
is placed on carpeting, rotate the adjustment
bolt liste more.
(Note) When placing the plano in its location, be careful nat to pinch tke power cable
underneath the plano.
(Note) When placing the plano on the stand, be careful not to pinck your fingers.
(Avoid holding the ends of the piano.)
© Align the screws (one on each sida) located
'on the bottom of the plano with the slots
in the metal fitings on the side
boards, Slide the piano so pz
the screws slide into the 1
ots. S La
A @ Lit up the piano ana use the two
» knob bolts to fasten the piano to
the stand.
SG
RS
> ——
® Rotate the adjusting bot
= : 3 unti it touches the floor,
LE