Physical Interfaces - Quantum SPARK 1500 Administration Manual

5. Click Apply.
6. In the Local Network table, right-click the mirror port and click Enable.
7. Repeat for each LAN port you want to duplicate in the mirror port.

Physical Interfaces

To edit a physical interface:
Configure the fields in the tabs. Note that for the DMZ there is an additional tab Access Policy:
The 'Configuration' tab
Assigned to - Select the required option:
n Unassigned - The physical interface is not part of any network and cannot be used.
n One of the existing configured switches or bridges
n Separate network - When selecting a separate network configure this information:
IP address
l
Subnet mask
l
DHCP Server settings
l
Select one of the options:
Enabled - Enter the IP address range and if necessary the IP address exclude
range. The appliance's own IP address is automatically excluded from this range.
You can also exclude or reserve specific IP addresses by defining network objects
in the Users & Objects > Network Objects page. Reserving specific IP addresses
requires the MAC address of the device.
Relay - Enter the DHCP server IP address.
Disabled
Note - When you create a switch, you cannot remove the first interface inside unless
you delete the switch.
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide
Configuring the Local Network
| 117