3 "Editor Setup" button
Click this to open the "Editor Setup" dialog and specify the MIDI Out port settings.
"Editor Setup" Dialog
This is where you set up the Voice Editor to allow the transmission/reception of voice data to/
from your synthesizer. Click the [OK] button to apply the settings and quit the dialog. Click
the [Cancel] button to quit without applying the settings.
Windows
1
2
3
4
5
1 MIDI In Port: ...........Click this and choose the MIDI In port. You can use the Voice Editor to
2 MIDI Out Port: ........Click this and choose the MIDI Out port. You can use the Voice Editor
n
If you are using a Macintosh, the MIDI Out Port setting is assigned in the OMS Port Setup. For
further details, see the section "OMS Settings"
3 MIDI Ch: ..................Click this and choose the MIDI Out channel. This is used when
4 Device No.: .............Click this and choose the MIDI device number of your synthesizer.
5 Dump Interval: .......Click this and choose the interval between successive MIDI dumps.
n
Setting this to too short of an interval may result in errors when transmitting MIDI data.
receive data sent from the device connected to this port.
to control and edit the device connected to this port.
monitoring sounds using the on-screen keyboard in the Edit
Windows.
Macintosh
(page
31).
11
3
4
5