Turning On The 3270 Pc - IBM 3270 Manual

Turning on the 3270 PC
If your control program is on a system diskette,
skip the next section and continue with the
section "Loading the Control Program from Your
System Diskette" on page 1-6.
If your control program is on your fixed disk,
continue with the next section, "Loading the
Control Program from Your Fixed Disk."
Loading the Control Program from Your
Fixed Disk
1. Turn off your system unit.
The On/Off switch is on the right side of the
unit.
2. If you have a color display, turn it on.
The On/Off switch for the color display is
located near the lower, right corner of the
display. The monochrome display does not
'have an On/Off switch.
3. If you have a monochrome or color display,
turn the brightness control clockwise as far
as it will go.
4. If you have an expansion unit, turn it on.
The expansion unit looks like the system unit
but it doesn't have any diskette drives in it.
The On/Off switch is on the right side of the
unit.
5. Turn on your system unit.
That's all there is to it. The next thing you will
see is the Power-On Self Test. Continue with the
section "Did the POST Run Correctly?" on
page 1-7.
Chapter 1. Turning on PC/Loading Control Program 1-5