Table of Contents
Advertisement
12. TROUBLESHOOTING GUIDE
12.2. Malfunction messages appearing on the display
> In the event of a malfunction, touch the ALARM
its error code (see following table).
> The message will be shown for 3 seconds, then it will go back to the HOME screen.
> To block the message on the screen, press the INFO button
screen for 30 seconds, then it will go back to the HOME screen.
> In the event that there is more than one error message, the display will show the different fault messages
in chronological order.
Display message
Power Failure!!
Upper unit open
Lower unit open
Replace filter
Upper unit too warm
Upper unit too cold
Refrigerator too warm
Refrigerator too cold
Lower unit too warm
Lower unit too cold
Error Code...
Check condenser
46
button and the display will show the fault message with
Malfunction description
Extended interruption of electrical power
The appliance starts up again automatically and indicates the highest recorded
temperatures. Press the ALARM
Fridge door open
This message appears when the door has been open for a few minutes.
Freezer door open
This message appears when the door has been open for a few minutes.
Replace filter cartridge
message appears when only 30% of filter capacity is left
Fridge too warm
See Troubleshooting Guide
Fridge too cold
wait for 12 hours: if the malfunction persists, call Customer Service for advice.
Fresco Compartment too warm
See Troubleshooting Guide
Fresco Compartment too cold
wait for 12 hours: if the malfunction persists, call Customer Service for advice.
Freezer too warm
See Troubleshooting Guide
Freezer too cold
wait for 12 hours: if the malfunction persists, call Customer Service for advice.
Functional problems
Contact Technical Service. Check the conditions of use (high food loads,
frequent door opening). Press the ALARM
alarm.
Check Condenser
Every 6 months the display shows the message "CHECK COND.", clean the
condenser and press and hold the ENTER button
www.fhiaba.com · sales@fhiaba.com · Info Line 800-344222
Modalità
on the display. The message will remain on the
Bottle Cooler
On
O
button to deactivate the sound alarm
button to deactivate the sound
for 5 seconds to reset.
Advertisement
Table of Contents
