Table of Contents
Advertisement
Extraction / Air Purifier Modes of Operation
EXTRACTION OPERATION – Installation Instructions
Ensure that you have fitted the
union ('N') to the upper part of the
hood using the packaged two
screws supplied inside the packing
(Fig. 1 – on right). Using a 125 mm
diameter pipe, connect the union
(N) on the upper part of the hood
(see Fig. 1) to the discharge outlet
for cooking vapours with a cross-
section of at least 150 cm ² .
PLEASE NOTE: If there is no
discharge outlet and the hood is to
be fitted to an outside wall of the
building, make a hole in the wall
that is large enough to fit a wind
and rain-proof shutter with a cross
section of at least 150 cm ² and
connect this to the outlet union of
the unit by means of a pipe.
__________________________________________________________________________________________________________________________________________________________________________________________________________________________
.
AIR PURIFIER (RECIRCULATION) OPERATION - Installation
Instructions
The cooker hood can be
converted to work as an air
purifier in the event that there is
no provision for an external air
discharge duct.
Please note: For the extraction function, you
will need to connect a 125 mm diameter outlet
chimney to the spigot 'N' in fig. 1 above. This
pipe is not provided with your cooker hood. See
figure on left.
In this case, air is recycled through
the vent 'R' (Fig. 1 – above). When
using the unit as an air purifier, you
need to install two active carbon
filters to absorb cooking vapours
(please see page 11).
Please note: For the air purifying
function, you will need to connect
the spigot ('N' in fig. 1 above) to the
connecting piece which is provided.
See figure on left.
18
Advertisement
Table of Contents
