Initialize Functions - Yamaha MU90R Owner's Manual

UTILITY MODE
4 From the "Are you sure?" prompt, press the ENTER button to ex-
NOTE
If you have more than one MU90R connected in your MIDI system and wish to send differ-
ent sets of data to each, you can specify a different Device Number for each. (See page 46.)
You should set the Device Number on each MU90R you use, before dumping the data to a
data storage device. Then, when you reload the data to the connected MU90Rs, each unit
will automatically receive only the data that has the corresponding Device Number.
Make sure that the devices are properly connected (see the Restoring Data
illustrations on page 119), and execute the appropriate data transfer operation
from the data recorder. (Refer to the owner's manual of that device for instruc-
tions.) The MU90R automatically receives incoming bulk data.
I n i t i a l i z e F u n c t i o n s
The Initialize functions allow you to restore the factory settings of the
MU90R.
NOTE
Since the Initialize functions replace existing data, you should save any and all important
settings to a MIDI data storage device before using these functions. (See page 119.)
Operation
1 Press the UTIL button and select "INITIAL," then press the
122
ecute the operation, or press the EXIT button to cancel it and re-
turn to the Dump Out menu.
A "Transmitting..." message appears in the display during the op-
eration. When the transmission is completed, the MU90R returns
to the Dump Out menu.
ENTER button.