Cd Synchronized Recording - Yamaha MDX-M5 Owner's Manual

RECORDING
Auto track marking
When making a recording, you can choose either
automatic or manual track marking. This feature
operates somewhat differently for analog and digital
signals. See below for details.
Press AUTO/MANUAL repeatedly to select automatic
track marking ("MANUAL" disappears from the display)
or manual track marking ("MANUAL" appears in the
display).
When recording analog signals
Auto: Track numbers are written in synchronization
with the input level of the signal being recorded. In
other words, if the source signal falls below a certain
level for more than 2 seconds, a track number is written
automatically the next time the source signal rises
above that level. You can change the level and time
settings (see page 16).
Manual: One track number is written automatically
when you start recording, but none are written during
recording. To write track number manually, press EDIT
at the desired point during recording.
When recording digital signals
Track numbers are written in the same positions as the
original source (CD, etc.) with automatic track marking.
When you set the unit to manual track marking, press
EDIT at the desired point to write track number during
recording.
Note
• When recording is paused, the portion recorded up to the
pause is counted as an individual track. When recording is
resumed, a new track number is created. On the other hand,
if one track is recorded in continuous repetition, that track is
recorded as one continuous track with a single track
number.
E-14

CD synchronized recording

You can easily record a CD on a MD when you
connect the unit to the CRX-M5.
This function is operated from the CRX-M5. For more
details, see the instructions of the CRX-M5.
1
Insert the desired disc into the CRX-M5.
2
Insert an MD.
3
Press DISC 1 – 3 to select the desired CD, then
press 7 after playing for several seconds.
4
Press CD SYNC when both units are in stop mode
and press 4/¢ repeatedly so that "CD
appears in the display.
5
Press CD SYNC .
The CRX-M5 starts CD play from the beginning of
a disc and the unit starts recording automatically.
6
Both units stop automatically when recording is
finished.
To stop CD synchronized recording
Press 7 (CRX-M5) or 7 (MDX-M5).
When you press 7 (MDX-M5) and the REC END
WRITING function set to ON, the CRX-M5 stops about
10 seconds after you press the button.
Notes
• You can record a CD on an MD with CD synchronized
recording by using various way as follows:
– recording from the desired track of a CD
– recording programmed track
• When the MD becomes full in the middle of the recording,
both units stop.
• Adjusting the VOLUME control of the CRX-M5 has no effect
on the recorded sound.
MD"