Preparing The Remote Control Transmitter - Yamaha MDX-M5 Owner's Manual

GETTING STARTED
Preparing the remote
control transmitter
Loading the batteries for the remote control
transmitter
1
Remove the battery compartment cover.
2
Insert 2 AAA size batteries into the battery
compartment.
–
+
+
–
3
Replace the battery compartment cover.
Battery replacement
If you find that the remote control transmitter must be
used closer to the main unit than usual, the batteries
are weak. Replace both batteries with new ones.
Notes
• Use only AAA batteries for replacement.
• Be sure the polarities are correct. (See the illustration
inside the battery compartment.)
• Remove the batteries if the remote control transmitter
will not be used for an extended period of time.
• If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in
contact with clothing, etc. Clean the battery
compartment thoroughly before installing new
batteries.
E-6
Remote control transmitter operation range
STANDBY/ON
Remote control
sensor
Notes
• There should be no large obstacles between the
remote control transmitter and the main unit.
• If the remote control sensor is directly illuminated by
strong lighting (especially an inverter type of
fluorescent lamp etc.), it might cause the remote
control transmitter not to work correctly. In this case,
reposition the main unit to avoid direct lighting.
Note
• This manual describes how to operate this unit by using
the remote control transmitter mainly. To operate the
unit from the front panel, use the corresponding buttons
on the front panel (see page 3).
REC LEVEL
REC
– +
0 10
Within approximately
6 m (19.7 feet)