Advertisement
113
INSTALLATION
1
2
3
6
5
10
8
9
7
4
11
1403893-2A-A
The finished wall
10
67~97
73108T-B4
NOTE: Install mounting box kit(1)
according to the rough-in dimensions of
98699T-B-NA.
Cut the protrudent part of the mounting
box kit out of the finished wall. Unscrew
the screw(2), remove the protect cover
kit(3).
①
Remove the protection(5) on the valve
kit(4). NOTE: Don't drop the o-rings(6).
The holes on the bottom of the valve kit
4
should be aligned with the holes in the
mounting box. Install the valve kit into
the mounting box kit, tighten the
screws(7).
Slide the cover kit(8) onto the valve with
the plugs(9) facing outside (NOTE:
Don't squeeze out the rings 10,11).
Push it against the wall. Secure it with
the screws(12).
12
②
15
73101T-B4
INSTALLATION CHECKOUT
Ensure that all coupling nuts are tight.
Ensure that the handle is in the off position.
Turn on the main water supply, and check for leaks. Repair as needed.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
2
1403893-2A-A
Slide the faceplate(13) onto the cover kit
with slots(14) downwards. Push it
against the wall. For ease of installation,
push up the valve stem(15) for about
12º degrees.
14
13
Make sure the bulge on bonnet(17)
align with the slots in the sleeve assy.
17
Press the bonnet into the sleeve assy.
16
Preassemble the screw(18) into the
handle(16). Install the handle on the
valve stem with the handle downward.
Tighten the screw from the bottom hole
of sleeve to secure the handle by hex
18
wrench(19).
③
19
The illustration shown is the correct
position of the handle in the off position.
④
73108T-B4
3
Advertisement
