Top Panel - Yamaha EMX3500 Operation Manual

Top Panel

A
O
B
P
I/O
Phantom Power Warning
To prevent hazard or damage, connect only microphones and cables that
conform to the IEC268-15A standard.
O Channel input connectors
Each of the EMX3500's input channels is provided with
both a balanced XLR connector (A) and a balanced tip-
ring-sleeve 1/4" phone jack (B). The channel's input
selector switch on the front panel is used to select
between these input connectors. Signal sources that
don't require phantom power should be connected to
the phone jack (B) when the PHANTOM POWER ON/
OFF switch is turned on.
Line
GROUND
HOT (+)
COLD (-)
8
1 2
XLR (A) Phone jack (B)
Pin 1 Sleeve
Pin 2 Tip
Pin 3 Ring
GND
S R
-
+
-
GND
(PHANTOM)
A PAD HA
B
Q
CD IN
A
-6dB
L
R
REC OUT
-10dBV
L
R
3
T
P Channel insert I/O jack
Each input channel has a tip-ring-sleeve 1/4" phone
jack that serves as an insert patch point for the connec-
tion of external signal processing devices or other
equipment between the channel's head amplifier (the
first amplifier stage after input) and the EQ stage. The
channel insertion point is ideal for the insertion of a
compressors, noise gate, equalizer, or other effect that
needs to be applied to a specific channel only. This
jack accommodates both the send (output) and receive
(input) lines required by the insert point. The signals
are sent and received at a nominal level of +0 dB.
TIP-RING-SLEEVE PHONE PLUG
Tip : output (send to external device)
T
+
Ring : input (return from external device)
R
EFFECT RETURN +4dB
B
1L/ 2L/
L
MONO MONO
R
1R 2R
TAPE IN LINE INSERT I/O +4dB
-10dBV
L L
L
R
R R
PRE GEQ POST GEQ
U
Sleeve :ground
S
EFFECT SEND +4dB
1
2
MONITOR OUT +4dB
A
B
V