Table of Contents
Advertisement
Insert the microphone plug into the MIC interface, and press
to switch to Standby mode to
amplify. Please wear the microphone well and properly adjust the microphone position and keep
about 50cm distance from amplifier to avoid howling.
3. Pairing operation between UHF wireless voice amplifier and UHF wireless transmitter:
The product has been paired before leaving the factory. It is not necessary to pair again, but it can be
used for wireless sound reinforcement. If it is necessary to pair again according to the actual situation.
Take the pairing operation of the voice amplifier and the S128 UHF Wireless microphone as an
example:
1) Please turn on the power switch of the voice amplifier, then press the
key to enter the "UHF
mode" with the corresponding prompt tone, and then press the
key to enter the "waiting for
pairing".
2) After turning the power switch of S128 transmitter to the "ON" power on state, press the volume
"+" button and the volume "-" button at the same time. The blue indicator will flash three times for
signal transmission. If the pairing is successful, the voice amplifier will give a voice prompt of
"pairing is successful". At this time, the voice amplifier can be used, and the voice amplifier can be
adjusted through "+" and "-"
3) If the voice prompts pairing failure, you can repeat the above two pairing operations.
4) Tips: This operation process is limited to wireless version only.
4. Volume control of the voice amplifier:
Rotate the volume dial to adjust the volume. Push the round button counterclockwise to increase the
volume and pull down clockwise to reduce the volume.
10 / 17
Advertisement
Table of Contents
