Electronic Cruise Control - Fiat TIPO 5DOOR 2023 Owner's Handbook Manual

in the event of sharp acceleration.
DEACTIVATING THE
DEVICE
To disengage the system press button
(1) fig. 160.
WARNING The activation of the
electronic Cruise Control will deactivate
the device.
Automatic off of the device
The device deactivates automatically in
the event of fault in the system. In this
case, contact a Fiat Dealership.
ELECTRONIC
CRUISE CONTROL
(where provided)
This is an electronically controlled
driving assistance device that
allows the desired car speed to be
maintained, without having to press
the accelerator pedal. This device can
be used at a speed above 30 km/h on
long stretches of dry, straight roads
with few variations (e.g. motorways).
It is therefore not recommended to use
this device on extra-urban roads with
traffic. Do not use the device in town.
152
ACTIVATING THE DEVICE
144) 145) 146)
To activate the device press button (1)
fig. 161.
The grey symbol on the instrument
panel switches on to signal that the
device is on.
1
161
The device cannot be engaged in
1 st or reverse gear: it is advisable to
engage it in 3 rd gear or higher.
WARNING It is dangerous to leave the
device on when it is not used. There
is a risk of inadvertently activating it
and losing control of the car due to
unexpected excessive speed.
SETTING THE DESIRED
SPEED
Proceed as follows:
to activate the device press button
(1) fig. 161;
when the car has reached the
desired speed, press button SET +
(or SET –) and release it to activate
the device. When the accelerator is
released, the car will keep the selected
speed automatically.
With the system set, the symbol
white.
If needed (e.g. when overtaking), you
can increase speed simply by pressing
the accelerator; when you release the
pedal, the car goes back to the speed
P2000320
stored previously.
When travelling downhill with the device
active, the car speed may exceed the
set one.
CHANGING THE SPEED
Increasing speed
Once the electronic Cruise Control
has been activated, the speed can be
increased by pressing button SET +.
Keeping the button pressed, the set
speed will increase until the button is
released, then the new speed will be
stored. Perform this operation only if
you want to increase car speed by a
high value.
is