Firmware Upgrade; Factory Reset; Hardware Reset - R volution PlayerOne 8K Quick Start Manual

Firmware Upgrade

Usually, if a new firmware is available, you will be informed at the player's startup. To access the
Firmware upgrade page and manually launch the online firmware's update, go to Setup >
Miscellaneous > Firmware Upgrade. You will see the current firmware version. Click on Check
Available Update. If a new version is available, you will be able to download it and install it. If there is
no new firmware version available, a popup windows will appear to confirm. To manually upgrade the
firmware using a USB flash drive, please visit rvolution.com > Download > R_volutionPlayer One
Firmware Updates.
rvolution.com/knowledgebase

Factory Reset

In case of problem, try turn OFF your media player and unplug the power cable during 10 min. It could
solve the problem. If it does not help, please try the following procedure. Be careful, however. This will
reset all your settings and account information. But you will not loose your movie collection.
1. Go to Setup > General
2. Click Reset Settings button, then click on Reset settings to confirm the procedure.
3. Please wait during the reset process.
Warning! Do not restart or switch off your player during the full process

Hardware Reset

If you do not get any video signal, you can boot into Recovery menu:
1. Start the media player.
2. During power-on press and hold the Reset button located on the back of the media player inside the
AV connector using a paper clip.
3. Then do "Wipe data".
DISCLAIMER
On some cases — especially if you come from a more recent firmware — during
the process, the TV screen can switch to GREEN or BLACK for a while. This is
normal! Please absolutly not restart or switch off your player during the full
process. In such case, please wait 10 min before to restart your media player.
Open
Paper clip
Paper clip
21