Install Access Panel; Check Operation - Whirlpool WDT730HAMZ Owner's Manual

Install Access Panel

– For Plastic, begin with step 61
– For Metal, begin with step 64
Plastic Panel:
61. Reinstall access panel and fasteners
A
A. Insulation (on some models)
Place the plastic access panel against the dishwasher leg.
Make sure insulation does not interfere with the float
assembly.
62. Check access panel edge
Check that the lower edge of the access panel touches the
floor. Adjust if necessary.
63. Tighten fasteners
1/4
turn
C
A. Unlocked
B. Locked
Using a flat-blade screwdriver, turn the fasteners 1/4 turn
clockwise to lock into place. The fastener slot will be straight
up and down when properly locked. Go to step 66.
24
A
B
1/4 turn
C.
Metal Panel:
64. Reinstall access panels
Place the panel against dishwasher legs. Using a Phillips
screwdriver or 1/4" nut driver, reinstall the screws through the
holes in the access panel.
65. Check lower panel edge
Check that the lower edge of the access panel touches the
floor. Adjust if necessary.
66. Tighten screws
Tighten access panel screws.

Check Operation

� Read the dishwasher Quick Start Guide that came with your
dishwasher.
� Check that all parts have been installed and no steps were
skipped. Check that you have all tools used.
If the dishwasher is not working properly, disconnect power or
unplug dishwasher and refer to the "If Dishwasher Does Not
Operate" section.