Table of Contents
Advertisement
Connect Fill Hose to Fill Valve
18. Tighten 90° elbow fitting to valve
Be sure rubber washer is properly seated in fitting. Slide the
3/4" (19 mm) fitting of the 90° elbow up to the valve and
hand-tighten to avoid cross-threading. Hand-tighten until the
coupling is tight. Using pliers, check the tightness of the
coupling. An additional 1/4 to 1/2 turn may be required to
seal the rubber gasket. Route fill hose out the rear left side of
unit.
NOTES:
� Do not use PTFE plumber's tape with compression
fittings.
� Do not overtighten. Damage to the coupling can result.
Drain Hose Connection
19. Connect drain hose
A. Small clamp
B. Rubber drain
hose
connector
C. Stop
Place towel under drain hose to catch any water in drain
hose. Place the small (green) drain hose clamp onto the
small end of the drain hose. Push the new drain hose into the
rubber drain hose connector up to the drain hose stop.
A
B
E
D
C
Drain hose stop
D.
Drain hose
E.
20. Slide clamp onto connector
B
A. Small clamp
B. Rubber drain
hose
connector
C. Stop
Using pliers, squeeze open the small drain hose clamp, and
slide it onto the connector between stops.
21. Hose clamp final position
C
D
A. Drain hose
B. Drain hose
stop
C. Small clamp
NOTE: Route drain hose out the rear of the dishwasher.
Power Cord Connection
NOTE: If removing a previous dishwasher with a power cord, you
will need to transfer the power cord to the new dishwasher.
22. Remove terminal box cover
Using a 1/4" hex-head socket, nut driver, or Torx
screwdriver, remove terminal box cover. Retain for later use.
E
A
D
C
Drain hose stop
D.
Drain hose
E.
A
B
E
Rubber drain hose
D.
connector
Stop
E.
®
T20
®
13
Advertisement
Table of Contents
