URBANGLIDE ECROSS PRO Original Manual page 29

To enter the settings of your product, press the "+" and "-" keys on your screen for 5 seconds.
Caution!
If you change all the basic settings, you will change the performance and status of your product. You
are advised to change only the settings below:
Work on this product should only be carried out by a qualified professional.
Menu
P01
P02
P04
0 = No sleep mode
P09
To begin with, we recommend checking the light beams (cables) for each error.
ERROR
Check that your battery is properly charged. If it is, check the state of the battery.
E06
E07
E08
E09
E10
If the cables are in good condition, the problem could be linked to the motherboard.
E11
E30
Go to your product settings by holding down the "+" and "-" buttons. Go to setting P20 and enter the
System settings
Setting
Brightness adjustment
Setting the distance measurement unit
0 = KM 1=MILES
Screen saving time
1 à 60 = The number of minutes of standby time
Startup mode
0 = Immediate start
Error code
PROBLEM
Battery fault
Engine fault
Check the condition of the motor(s).
Trigger fault
Check that the throttle trigger is in good condition.
Motherboard fault
Replace the motherboard.
Electrical harness fault
Electrical harness fault
This problem may be caused by the motherboard.
Communication fault
value 0.
29
1 = Impulse to start