Pipeline box Instructions For Use Manual page 11

Hide thumbs Also See for box:
Table of Contents

Advertisement

Available languages

Available languages

I I . G E T T I N G S T A R T E D
Follow the steps below to get your new PIPELINE BOX up and running:
1. Open the battery compartment by unscrewing the battery cap.
2. Insert a compatible and fully charged battery into the battery compartment.
Ensure the correct orientation of the battery poles! Use high-discharge Li-ION batteries
(single, unprotected, flat-top) only! For higher power ranges (>20 watts), we strongly
recommend using batteries with a discharge current of at least 20 amperes!
3. Close the battery compartment by screwing on the battery cap.
To operate with an 18500 or 18350 battery cell, you must use a corresponding-sized
battery cap (not included)! In the default configuration, the PIPELINE BOX can only be
used with an 18650 battery!
4. Attach a compatible and functional 510 atomizer to the 510 connector.
Always follow the manufacturer's instructions and guidelines when setting up your
atomizer!
5. Press the fire button 5 times in rapid succession to activate the PIPELINE BOX.
For additional important information and usage guidelines, refer to the user manual
provided below!
20 English
I I I . I N S T R U C T I O N M A N U A L
POWER ON/OFF
After inserting a battery, press the fire button 5 times in rapid succession to activate the
device. If you wish to permanently deactivate the device, remove the battery or briefly
disconnect the device from the battery by loosening and then tightening the battery cap a
few turns. All settings made will be retained even after deactivating the device!
STANDBY MODE
To ensure maximum battery life, the PIPELINE BOX enters standby mode approximately
60 seconds after the last button press. Any button press will reactivate the device (instant
puff).
BUTTON LOCK
To prevent accidental button firing (e.g., during transport), you can activate the button
lock. To do this, press the fire button 5 times in rapid succession. Repeat the process to
unlock the buttons.
NAVIGATION BUTTON LOCK
Press both navigation buttons simultaneously for 3 seconds to lock them. This will fix the
set of power [W] or temperature [F/C] to prevent unintended changes while keeping the
fire button functionality intact. Repeat the process to unlock the navigation buttons.
English
21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the box and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents