Olimpia splendid Bi2 WALL AR 1000 Instructions For Use, Maintenance And Installation Manual page 33

is rotating at high speed, it will cause injury.
27. Never use a flammable spray such as hair spray, lacqueror paint near the unit. It
may cause a fire.
28. Never touch the air outlet or the horizontal blades while the swing flap is in
operation. Fingers may become caught or the unit may break down.
29. Do not obstruct the air inlet and outlet grids in any manner.
30. Do not insert extraneous items in the air inlet and outlet grids as this will create the
risk of electrical shocks, fire or damages to the appliance.
Objects touching the fan at high speed can be dangerous.
31. Do not inspect the unit or perform maintenance personally. Repairing the appliance
yourself is extremely dangerous. Contact a qualified professional.
32. Do not dispose this product as unsorted municipal waste. Collection of such waste
separately for special treatment is necessar.
33. If the appliance is installed and used in a small room, the concentration of water
(condensate) must be kept within the limits because a leak would reduce the
cooling capacity.
Contact your dealer to prevent water leaks.
34. Turn off any combustible heating devices, ventilate the room, and contact the
dealer where you purchased the unit.
Do not use the air conditioner until a service person confirms that the portion
where the water leaks is repaired.
35. The most common cause of overheating is dust or lint deposit in the appliance.
Regularly remove these accumulations by disconnecting the appliance from the
power socket and vacuuming the grids.
36. If an appliance of this type is no longer to be used, it is recommended to make it non-
operational by cutting the power supply cable, AFTER it has been disconnected
electrically. Hazardous parts of the appliance must be rendered harmless, especially
as there is a risk of children playing with it.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
CAUTION
1. Before installing the unit, it is necessary to check whether the ground wire is
charged.
If it is, the unit shall not be installed before correction.
2. Ground the air conditioner.
Do not connect the ground wire to gas or water pipes, lightning rod or a telephone
ground wire. Incomplete grounding may result in electric shocks.
3. Be sure to install an earth leakage breaker.
Failure to install an earth leakage breaker may result in electric shocks.
4. It is not allowed to connect the appliance to the power supply before the electric
wiring and hydraulic connection have been performed.
5. While following the instructions in this installation manual, install drain piping
in order to ensure proper drainage and insulate piping in order to prevent
condensation.
Improper drain piping may result in water leakage and property damage.
6. Install the appliance, the power supply cables and connection cables at a distance
of at least 1 metre from television and radio appliances in order to prevent
interference on the images or noise. Depending on the length of the radio waves,
1 metre may be insufficient to eliminate noise.
7. Don't install the air conditioner in the following locations:
• There is petrolatum existing.
• There is salty air surrounding (near the coast).
• There is caustic gas (the sulfide, for example) existing in the air (near a hot spring).
• The Volt vibrates violently (in the factories).
• In buses or cabinets.
• In kitchen where it is full of oil gas.
• There is strong electromagnetic wave existing.
Bi2 WALL AR 1000 - 1200 - 1400
EN - 5