TRIBU OTTO round dining table Assembly Instructions Manual

ASSEMBLY INSTRUCTIONS

OTTO

round dining table

Table of Contents

Need help?

Do you have a question about the OTTO round dining table and is the answer not in the manual?

Page 1 ASSEMBLY INSTRUCTIONS OTTO round dining table...
Page 2 ASSEMBLY INSTRUCTIONS TRAVERTIN TABLE Ø 148 CM CONTENT Travertin table top frame 12 x Base Bolt M6 Bumpon Wrench...
Page 3 Place the base on the wanted location and lift the frame onto the base. Mount the frame against the base by screwing the 4 bolts through the frame into the inserts of the base. If the floor is not perfectly level, use the provided wrench to adjust the height of the gliders under the base.
Page 4 Place bumpons on top of the table frame, divided as shown below. Remove the liner and adhese the bumpon to the frame. Make sure the bumpons are 0.5 cm away from the edge. Place the travertin top onto the frame.
Page 5 ASSEMBLY INSTRUCTIONS CERAMIC TABLE Ø 148 CM CONTENT Ceramic table top Base Bolt M6 Wrench...
Page 6 Place the base on the right place and lift the ceramic top onto the base. Make sure the top is concentric with the base. If the floor is not perfectly level, use the provided wrench to adjust the height of the gliders under the base.
Page 7 Turn the table top until the inserts match with the holes in the base. Mount both parts against each other by screwing the 4 bolts through the base into the inserts of the ceramic top.
Page 8 04266-CX 04266-TV Tribù nv Oude Heidestraat 72 3740 Bilzen BELGIUM www.tribu.com info@tribu.com...