Chapter 5 - Operations; About Status Led Ring; Tvoc Sensor Reading; Pm 1 And Pm 10 Sensor Reading - Honeywell TR50 User Manual

Indoor air quality sensor

Hide thumbs Also See for TR50:

Table of Contents

CHAPTER

OPERATIONS

The LED status ring colors are configured for data points to indicate the conditions

of the parameters that may require control. IAQ Sensor TR50 device helps to view

and manage the parameter readings through LED ring. This LED ring is available

in both with display and without display modes. Refer

Indication

•

When the TR50 device is powered up out of the box, it takes at least 48 hours to

stabilize the TVOC sensor without power interruption,

•

In addition, whenever the device is powered off, the TVOC sensor needs some

time to baseline its data. The long if the device is powered off, the more time is

needed to complete this baseline process. Normally it can complete between a

couple of minutes to 2 hours.

So only after this stabilization and baseline time the TVOC reading is effective.

TR50 provide independent sensor measurement channel for PM1 and PM10, it is

not calculated out of PM2.5

TR50 - User Guide

section on page 11 for more details.

LED Ring Behavior /

Table of Contents