Yamaha 02R96 Supplementary Manual page 6

[THXM] THX Music
This preset is configured for DVD-Music production. Use this preset when mixing and/or
monitoring multi-channel music content (including DVD-Audio and SACD). Only one
parameter can be changed. The LFE gain (AMP) can be set to +10dB (default) or 0dB. Select
the level that complies with the standards of the target media. Please note: The LFE output gain
on some DVD players, receivers, and/or decoders may already be set to +10dB. Select the 0dB
setting only if the destination environment (home theatre, etc.) has the LFE gain set to 0dB.
Otherwise, use the default setting.
• MONITOR ALIGNMENT ATT & DLY ON/OFF
These buttons are used to turn on and off the Monitor Align-
ment Attenuator and Delay parameters of all Surround speak-
ers. The MONITOR ALIGNMENT diagram and Surround
Channel Attenuator and Delay parameters, which are dis-
played when either of these buttons are selected, allow you to
align the surround monitor speakers by attenuating and
delaying Surround Channels as necessary. The Attenuator
parameters can be set – ∞ , –12 dB to +12 dB in 0.1 dB steps. The Delay parameters can be set from
0 to 30 msec in 0.02 msec steps.
Note:
• Please note that the above settings apply only to the signals being monitored. They do not
affect the normal bus outputs.
• If you're monitoring in surround mode 6.1 and monitor matrix mode 6.1, you'll need to
make the above settings separately from when in other modes.
Tip: The settings you make here can be stored in the surround monitor library.