Log Is Lying On The Ground; Limbing; Troubleshooting - Parkside PGHSA 20-LI B1 User Manual

˜ Log is lying on the ground
Saw through the log completely from above
and ensure at the end of the cut not to contact
the ground . If you can turn the tree trunk, saw
two-thirds of the way through it . Then turn
the trunk around and saw the rest of the way
through from above .
˜ Limbing
Limbing is the designation for the sawing off of
branches and boughs from a felled tree .
m WARNING!
Many accidents occur during the removal
u
of branches . Never cut tree limbs when
you are standing on the log . Keep the
spring back area in mind if branches are
under tension .
˜ Troubleshooting
Problem
Device does not start
Inferior cutting
performance
Saw runs with
difficulty, chain comes
off
Chain becomes hot,
smoke development
during sawing,
discolouration of the
rail
20 GB
434668_2304_CZ_SK_HU_SI_02.indb 20 434668_2304_CZ_SK_HU_SI_02.indb 20
Possible cause
The battery pack is
[ 12 ]
empty or not inserted
Defective On/Off switch
[ 4 ]
Defective motor
Incorrectly mounted saw
chain
10 ] [
Saw chain blunt
10 ] [
Chain tension insufficient Check chain tension
Chain tension insufficient Check chain tension
Too little chain oil
Do not remove support branches until after
the sawing off .
Branches under tension must be sawed
from below to above, in order to prevent
jamming of the chainsaw . When working
on thicker branches, use the same technique
as when you are sawing up a felled trunk .
Work to the left of the log and as near as
possible to the electric chainsaw . As far as
possible, the weight of the saw should rest
on the log .
Change position to saw off branches on the
other side of the trunk .
Branches sticking out are cut off separately .
Fault correction
Check the charge level . and have repairs
carried out by a qualified electrician, if
necessary .
Have repairs carried out by a qualified
electrician, if necessary .
Mount saw chain correctly
Sharpen cutting teeth or place on new chain
Chain lubrication
11/3/2023 12:17:24 PM 11/3/2023 12:17:24 PM