Table of Contents
Advertisement
Configuring the MCs
Table 2-2. General Setup Menu Parameters (cont.)
2-8
Auto Scroll
On
Off
Auto Wrap
On
Off
Received CR
CR
CRLF
Auto Page
Off
On
Warning Bell
Off
On
Margin Bell
On
Off
When the cursor moves past the last line on the page:
The data scrolls up one line at a time.
It returns wraps around to the top of the same page.
When characters are entered at the end of a line:
The cursor wraps to the start of the next line.
Characters at the cursor position are overwritten.
When the MCs receives an ASCII CR (carriage return)
character, the cursor will move to the beginning of the:
Current line.
Next line.
When the cursor reaches the top or bottom of the page:
It wraps around and data scrolls up and down the
page, depending upon the Autoscroll parameter
selection.
A new page of memory moves onto the screen.
When Virtual Terminal mode is set to On, the MCs's
bell:
Does not sound when the inactive session receives
data.
Sounds repeatedly when the inactive session receives
data from the host.
The MCs's bell:
Rings when the cursor reaches the column where the
bell is set (default is column 72 in 80-column mode,
and column 124 in 132-column mode).
Does not ring when the cursor approaches the right
margin.
MCs User's Guide
Advertisement
Table of Contents
